Riding Mower Deck Belt for John Deere Tractors. Do not twist the belt. Oil should flow from the plug hole. Turn right blade E so blade tip points straight forward. Install the new belt on the sheave that is under the gearbox. Thank you for shopping Home Depot. Raise the cutting height to the next highest position and remove the three wooden blocks.
Install the new roller on the shaft. Remove the three belt shields. Pour or squirt oil through the fill plug hole until the oil runs out of the check plug hole. To remove the shields, open the three latches shown. Use a bar to lift and hold up the rear of the gearbox. Install the outer shields first, then the center shield. Hold drive belt and turn right blade D as shown.
Tighten bolts to 68-75 N·m 45-55 lb-ft. Repeat procedure until rear corners of the mower deck are level. Lower mower deck to the 50 mm 2 in. Sharpen blades with grinder, hand file or electric blade sharpener. The Kevlar V-Belts are manufactured to withstand the heat oil and back idler pulleys often associated with outdoor power equipment. Turn the gearbox on it's side to drain it. Install and tighten the lock nut.
Pricing may exclude any added parts, accessories or installation unless otherwise noted. Replace blade s if damaged. If you do not balance a blade, it may vibrate too much. Put blocks in front of the mower. For belt driven mower, adjust side to side as follows a. Mower wheel must not be on the ground.
Tire pressure is marked on the side of the tire. To help prevent injury when you handle the blades, wear heavy gloves or wrap the end of the blade with a rag. Tighten the cap screws and bolts to 70 N·m 50 lb-ft. You know you'll be able to get the job done right with Arnold. Measure from blade tip to the surface. Gear Tractor Deck Belt Get more durability with the Kevlar V-Belts.
Arnold's wide variety of high-quality parts, including belts, will add years of life to any mower, tractor, trimmer or chore performer. Turn the outer mower blades on right and left side to point straight forward. Do not change the bevel. Bolts to open them are conveniently located under the air filter cover. Poly cord belts have high resistance to elongation and are antistatic oil and heat resistant. Two debris inspection ports help ensure clean engine fins for optimum cooling. Take measurement for both blades.
Craftsman and Husqvara Lawn Tractors 197253 Arnold has everything you need to keep equipment Arnold has everything you need to keep equipment running the way it should season after season. Grease Use the following grease based on the air temperature range. Is it as simple as making sure the bottom of the deck is parallel with the ground, or is there more too it than that? With Arnold you can be confident of a reliable product with accurate fit design material and construction. Use of this site is subject to certain. Turn nut to either lift or lower left side of mowr. Remove the two cap screws A from in front of the gearbox. Remove the three mower deck belt shields.
If you put your hand or foot between the moving belt and a sheave, the belt and sheave can tear your hand or foot off. M17687a Picture Note: 107 cm 42 in. Make sure machine is on a flat, level surface. Check distance, Adjust if necessary. Our universal parts for lawn mowers, snow throwers and other equipment are compatible with most makes and models, so anyone can easily find the parts their machines need. Changing The Mower Deck Gearbox Oil 1. If the two measurements are not equal, turn the leveling nut B on each rear lift link to adjust.
Adjust mower deck level if necessary. For any other questions, please call us at HomeDepot. Check that the mower deck is level and lightly touching each of the three wooden blocks. Lower mower until the bottom of mower deck is approzimately 3in. The heavy end of the blade will drop. Thank you for shopping Home Depot.