The engine will continue to run at idle speed until the lever move to 22. Install the thrust washer and propeller on the propeller shaft. Proper mounting depends in part on experience and the specific boat and motor combination. Low oil pressure-alert indicator 10. Overheat-alert indicator tus and alert information. In such an event, stop the engine immediately and see page 123 of this manu- al to drain the water from the fuel filter. For Canada In the U.
Starboard side control lever engine will run at the average speed of 3. Check the cooling water inlet for clogging. For example, if the center electrode. Consult your Yamaha dealer if the problem cannot be located and corrected. Consult your Yamaha dealer if the problem cannot be located and corrected. Is specified fuel not being used? Water separator-alert indicator called the Multi-Display shows engine sta- 9.
Vessels with tinctive shapes and colors to show regulatory trolling lines are not considered fishing ves- or advisory information. Does the Digital electronic control-alert in- dicator come on? Center port side engine 5. Oil pressure 4-stroke models Do not continue to run the engine if the 8. Close the throttle so that the engine slows to idle speed. Single type After using the free throttle switch, return the control lever to the neutral position. The free throttle switch will return automatically to its set position.
You should periodically remove and check the spark plug because heat and deposits will cause the spark plug to slowly break down and erode. Remove the key if the boat will be left un- attended. Have serviced by a Yamaha dealer. Ignition coil To install the spark plug Wipe off any dirt from the threads, insu- Bolt tightening torque: lator, and gasket surface of the spark 9 Nm 0. Are spark plugs fouled or of incorrect A. Instead, take the out- board motor to a Yamaha dealer.
Get back to the port soon and consult a Yamaha deal- er immediately. Water detection-alert indicator Yamaha dealer. Low battery voltage-alert indicator The Command Link Plus Display hereinafter 8. After the engine is at idle speed in gear move the control lever firmly and crisply into the neutral position. Be alert for conditions that limit your Boating Accident Report with their boating visibility or block your vision of others. After tilting the outboard motor, be sure to support it with the tilt support knob or tilt sup- port lever. The original Yamaha paint sur- Consult your Yamaha dealer for details.
Station selector switch panel 3. Have outboard motor adjusted to proper Q. Switch panel for use with quad type 5. Fuel pump fuse 15 A immediately blows again. Otherwise the outboard motor could fall back down suddenly if oil in the power trim and tilt unit or in the power tilt unit loses pressure.
Battery for starting nected, or the battery will not start the 7. Select Minimum marine cranking amps a propeller that will allow the engine to reach. Push the engine selector switch once to operate the port side and starboard side engines. Severe injury could occur if the outboard motor accidentally falls. If the en- gine idle speed is out of specification, consult a Yamaha dealer or other quali- fied mechanic. Consult your Yamaha dealer if the oil level is not at the proper level or if it ap- pears milky or dirty.
Starboard side control lever 3. Body parts can be crushed between the outboard motor and the clamp bracket when the outboard mo- tor is trimmed or tilted. Keep this manual onboard in a waterproof bag when boating. Seal replacement should be per- movement which can bring in water through formed by an authorized Yamaha dealer condensation as the air temperature chang- prior to use. The engine can not be started when the digital elec- tronic control-alert indicator lights.